RCU Forums - Search Results

Search: Posts Made By: Skycam41

Showing results 1 to 8 of 8
Search took 0.05 seconds.

Forum: ARF or RTF

01-16-2018, 05:50 AM

Replies: 8,173

Larger Revolver

Views: 876,435

Posted By Skycam41

Hi Chris, send me a PM with your address and...

Hi Chris, send me a PM with your address and phone number. I'll mail it out and when I get back from the post office I'll PM you with the cost and then you can PayPal me the funds (it won't be much...

Forum: ARF or RTF

01-15-2018, 08:08 PM

Replies: 8,173

Larger Revolver

Views: 876,435

Posted By Skycam41

I have the stock tank but bought a DuBro to...

I have the stock tank but bought a DuBro to replace it so if you want mine you are welcome to it. Just pay the shipping and it's yours (I'm in Canada).
Mike

Forum: ARF or RTF

12-30-2017, 11:27 AM

Replies: 8,173

Larger Revolver

Views: 876,435

Posted By Skycam41

Thanks, I thought that also as I'm just about at...

Thanks, I thought that also as I'm just about at that point :D

Forum: ARF or RTF

12-30-2017, 10:05 AM

Replies: 8,173

Larger Revolver

Views: 876,435

Posted By Skycam41

Had to cut a lot off the bottom of the cowl so...

Had to cut a lot off the bottom of the cowl so the muffler and pipes would fit but oh well.

I've got a question in regards to installing and gluing the horizontal stabilizer. Do I slide it into...

Forum: ARF or RTF

12-27-2017, 09:45 AM

Replies: 8,173

Larger Revolver

Views: 876,435

Posted By Skycam41

Using the method shown in the video above I've...

Using the method shown in the video above I've made the engine head exit.....needs a little touch up with sandpaper and then to make the exhaust pipe and needle valve exit to complete.

Forum: ARF or RTF

12-22-2017, 04:57 PM

Replies: 8,173

Larger Revolver

Views: 876,435

Posted By Skycam41

That was great!! Thanks for posting the link :)

That was great!! Thanks for posting the link :)

Forum: ARF or RTF

12-22-2017, 04:40 PM

Replies: 8,173

Larger Revolver

Views: 876,435

Posted By Skycam41

Best way to mark cut outs for cowl?

I've built a dozen or so planes in my time but have never had to mark out the cut outs on the cowl for the cylinder head and muffler stacks.....any suggestions will be welcome.

Forum: ARF or RTF

12-20-2017, 01:30 AM

Replies: 8,173

Larger Revolver

Views: 876,435

Posted By Skycam41

I just discovered this thread after reading a...

I just discovered this thread after reading a much smaller thread on RCG. I just bought my Revolver 70 and fabricated my landing gear brace as suggested by others. I have a newer OS .91FX (been...

Showing results 1 to 8 of 8