RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Jim Cattanach
Showing results 1 to 7 of 7
Search took 0.07 seconds.
Forum: RC Jets
05-04-2009, 01:31 PM
Replies: 5,088
Views: 1,237,126
Posted By Jim Cattanach

RE: Bob Cat Copy Falcon 120 Jet

The length of the tube should be 515mm. Diameter is 20mm.
Be aware that the blanked off tube end formers may not line up exactly with the tube ends. I had to clear out some glue by using the old...
Forum: RC Jets
05-04-2009, 11:05 AM
Replies: 5,088
Views: 1,237,126
Posted By Jim Cattanach

RE: Bob Cat Copy Falcon 120 Jet

Was flying my Falcon the other day with a Wren 54. A friend who was watching said he saw one of the wings flexing quite a lot during the flight. When I landed, I noticed one wing had more up & down...
Forum: RC Jets
10-12-2007, 10:59 AM
Replies: 5,088
Views: 1,237,126
Posted By Jim Cattanach

RE: Bob Cat Copy Falcon 120 Jet

Tim. I did not use mine. PM me your address & I will post it to you.
Regards
Jim
Forum: RC Jets
10-09-2007, 02:37 AM
Replies: 5,088
Views: 1,237,126
Posted By Jim Cattanach

RE: Bob Cat Copy Falcon 120 Jet

Your vehicle must be very wide to take the 64" width. My Mondeo estate is about 6" to narrow & I thought it was wide.
Forum: RC Jets
10-09-2007, 12:09 AM
Replies: 5,088
Views: 1,237,126
Posted By Jim Cattanach

RE: Bob Cat Copy Falcon 120 Jet

For transportation, I just take off one wing complete with boom & remove the stab. Just takes a couple of minutes & it fits in the car fine.
Forum: RC Jets
10-05-2007, 11:01 AM
Replies: 5,088
Views: 1,237,126
Posted By Jim Cattanach

RE: Bob Cat Copy Falcon 120 Jet

The whole point of having the tube go through the fuse from one side to the other is so it has strength. Cut the middle out & you might as well not use it at all. You could hysol the outer parts of...
Forum: RC Jets
10-03-2007, 12:58 PM
Replies: 5,088
Views: 1,237,126
Posted By Jim Cattanach

RE: Bob Cat Copy Falcon 120 Jet

If you cannot see through the tank to see the fuel level, just fit a right angled festo in the top front face of the tank & another at the bottom. Connect them with 4mm clear festo tubing & you have...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.